jerryleo's Replies | OpenSprinkler

Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)

Author

Posts
July 26, 2020 at 1:28 am in reply to: OpenSprinkler 3.2 BOM Master + AC questions #67529

jerryleo
Participant

Hi Steve,

C0 and C1 are the same. The only difference ist the package. C0 is the through hole version and C1 the SMD. You only need either one, not both.

June 11, 2020 at 4:07 pm in reply to: Picture of controller #66776

jerryleo
Participant

Hi Ray,

Once more… Do you have a pic of the zone expander 3.1?

Thanks

June 11, 2020 at 4:05 pm in reply to: OpenSprinkler 3.2 BOM Master + AC questions #66775

jerryleo
Participant

Hi Ray,

Is there a BOM for the zone expander3.1?

Thanks,
Jerry

May 9, 2020 at 8:21 pm in reply to: Picture of controller #65880

jerryleo
Participant

Great!

May 9, 2020 at 1:28 pm in reply to: Picture of controller #65870

jerryleo
Participant

Hi Ray,

Could you post the same for the 24VAC power board?

Thanks, Jerry

May 9, 2020 at 11:34 am in reply to: Picture of controller #65867

jerryleo
Participant

Thanks Ray

October 11, 2018 at 12:57 pm in reply to: rf send proto 5 #52935

jerryleo
Participant

Hi Ray,

I have the same problem and just found this… I’ll start looking for where to change that, which I already have. While I’m searching again, could you tell me where it is? I’m sure already that i won’t find it.

Thanks,
Jerry

Found it…..

October 10, 2017 at 3:43 pm in reply to: Modifying the firmware #48026

jerryleo
Participant

Thanks… that did it.

October 7, 2017 at 3:12 am in reply to: Modifying the firmware #47932

jerryleo
Participant

Hi,
I’m having the same problem. Has anyone found a solution yet?
Thanx
Author

Posts

Viewing 9 posts - 1 through 9 (of 9 total)