[robm]

Here is a pic

Attachments:

1. 

   317802384_3350374215234030_6743763350023585551_n-1.jpg
   

[robm]

Version 3.0

[robm]

I also just tested voltage across the common and each station terminal, and there was nothing. Why would this have worked at home, yet when i transported it to work, it stopped? Are there any components on the board i can check? I am comfortable with circuit board repairs. It appears to me that the system is not outputting anythign – although i, still not convinced its just a hardware issue alone, since the machine appears to restart whenever you start a station (see above post where i mention the welcome screen “connecting…./NTP synch” appears whenever you go to start a station

[robm]

Thanks Ian – good to hear from a fellow Aussie – i am in Townsville!

So are you suggesting to try and update the firmware with a laptop. I’m not sure if this means updating via wifi (which i don’t think will work as i can’t connect to OS), or via a cabled connection between the laptop and OS? Then once firmware is updated it should be right?

I do recall updating firmware around 12 months ago, but maybe will try again.

Thanks

[Author]

Posts