Forum Replies Created
-
Posts
-
Pretty sure isn’t confirmation! I’ve tried both 64 and 32 bit versions. Guess I need to figure out how to install a older version.
Thank you for the reply Ray. No errors. Clean buster installation with OpenSprinkler.
Can you confirm buster x64 works?Why the change? I bought off Amazon, wasn’t a choice for 2.X so I got the wrong one.
How is addressing determined one v2? No jumper…i think it is limited to 500mA, so 2.5 watts…
i got my main board, so let it be known my expansion board is also dead… so anyone with a lightning strike, the whole system needs to be replaced. trash it all…
iPad app…
Attachments:
https://dashboard.ambientweather.net/dashboard
I’ve been reporting my data to Ambient Weather, which gives free access to your data. there is a apps for phons, iPads and for SmartThings, which updates every minute, and ambient weather also has IFTTT integration.
I’m running a meteobridge device, see screen shot below, which uploads to ambient, PWS network, WU, and CWOP..
Attachments:
I see the weather api link at the bottom of their page, but that appears to be the old system.
i have a windows 10 computer on wifi and it has a problem getting back a network connection after the dhcp lease has expired… this started about about 6-9 months ago. i’m on a r8000 router running as access point and clearOS as my firewall/router. for some reason i think this is something netgear changed in their firmware… are u guys with problems on netgear hardware???
It is probably a problem with renewing the dhcp lease, probably try static IP address. I set my dhcp lease as static on my dhcp server (router).
If I reset my access point I find I have to power cycle usually. My OpenSprinkler is plugged into a smart outlet so I can do it remote.
edit: i’m running on raspberry pi
I think WU site is busy because of Irma, and perhaps OpenSprinkler timeout period needs to be increased.
Same problem. For some reason it says i have exceeded my rate allowed and have used 2 rain drops the last two days.
You could use two sprinkler valves per bowl, one to flow unrestricted to flush, and the the second with a restricter to fill.
I think easiest is to log in with monitor and keyboard.
Set wifi using the following instructions https://www.raspberrypi.org/documentation/configuration/wireless/wireless-cli.mdI do wish there was a pkg to connect to wifi like Amazon Echo and Skybell. Would need input button on OpenSprinkler board to reset wifi to access point.
